Muratec PLAIN-PAPER DIGITAL FAX/COPIER/PRINTER/SCANNER MFX-1330 - Manual (Page 127)

8.5 S
PECIAL FEATURES
1
2
3
4
5
6
7
8
11
12
13
14
A
S
PECIAL
FEA
TURES
Creating or modifying a Macro
1
Press
MACRO PROGRAM
.
1.Set Macro

/  /Enter
2
Press
ENTER
.
Select Macro Key
M1:No Command Stored
3
Press the Macro key you want to create or modify.
Then press
ENTER
.
4
If you are creating a new macro, skip to next step.
If you are modifying the macro already stored, the following two displays will appear
alternately.
M1:Overwrite?
Yes  Enter
M1:Overwrite?
No  Cancel
• To overwrite the recording, press
ENTER
.
• To change only the macro name, press
CANCEL
and go to the step 9.
5
The copy standby display appears and the machine begins to beep which indicates the
machine is in the macro programming mode.
Copy Ready 01
Auto Ltr 100%
6
Press the keys exactly as you operate the job you want to program into a macro key.
• The machine beeps during programming to confirm macro programming mode.
• You can program up to 60 steps. When it comes over 60 steps, the machine asks if
you want to register the operations you have entered.
Too Many Steps
Yes  Enter
Too Many Steps
No  Cancel
If you want to register them, press
ENTER
.
If you want to abort, press
CANCEL
.
• When you press ENTER
or
START
at the end of operation you are programming, the
machine shows:
Include Start/Enter?
Yes  Enter
Include Start/Enter?
No  Cancel
If you want the machine to start the programmed operation immediately by press-
ing the macro key, press
ENTER
.
If you want the machine to prompt you press
START
or
ENTER
before starting the
recorded operation, press
CANCEL
. Then go to the step 8.
7
Press
MACRO PROGRAM
.
M1:Name ;Upper
_
The machine prompts you to enter the name of macro.
If you do not want to enter or change it, skip to the step 9.