MACKIE Digital Mixers - Manual (Page 12)

12
Acuma Time Pak
Input Select
Assign Time Pak’s stereo inputs from any of the D8B’s pre, post
or auxiliary channels.
Menu Button
This button enables familiar functions such as undo, redo, load,
save, reset, cut, copy and paste.
Input and Output Meters
The input meters represent the incoming signal from the D8B as
two rows of LEDs. The output meters represent Time Pak’s
output. The output levels are controlled by the Master Input
Sliders located on the far right-hand side of the GUI.
Minimize and Close Buttons
These buttons will minimize, expand, or close the Time Pak
window. The minimized window condenses the various sliders
and parameters into an area just below the node display. The
parameters can still be adjusted using the mouse over each box.
The meters are compressed to the left edge of the minimized
window.
The minimized display shows this selection of
parameters, instead of the Pan Slider.
Menu
Button
Preset Window
Input Select
Input
Meters Simplify/
Close Output
Meters
Mode Select
The meters are compressed
to fit on this side