MACKIE Digital Mixers - Manual (Page 16)

16
Acuma Time Pak
Pan Modulation
The Pan Modulation control lets you assign
preset waveforms to modulate the pan of a
selected node. By clicking the up and down
arrows found at the right of the Pan
Modulation display, you can choose between
graphically illustrated waveform presets
representing a variety of sine waves, triangle
waves, inverted triangle, square waves, and
two separate envelope followers.
You can also change the phase of a selected
waveform by grabbing the graphic with your
mouse and moving it to the left or right,
placing the modulation in or out of phase.
The phase increments are measured in degrees and are
represented by the top set of numbers just to the left of the
waveform window.
There are two separate envelope followers
that are included in the collection of preset
waveforms. Although an envelope follower is
not technically a waveform, the regular
controls will apply. To control the threshold of
Envelope Modulation 1 and 2, use the mouse to grab the
horizontal white line that separates the window.
The modulation RATE is controlled with a
slider and is measured in beat ratios that are
directly linked to the master tempo. The
DEPTH of the modulation is also controlled
with its own slider and is measured in
percents. The block numbers just to the left of the sliders
represent the values of the rate and depth sliders.
Toggle Buttons
Note: Note: Note: Note: Note: Envelope Mod 1 shifts the modulation up while
Envelope Mod 2 shifts the modulation down.