Metrologic Instruments MS9524 - Manual (Page 18)

14
A SSEMBLING THE S TAND (C ONTINUED )
Stand Option 2: Hard-mounted to countertop (continued)
For use with kits #46-46128, #46-46351 and
MS951 Stand Replacements
Step 3
Screw the stand anchor ( MLPN 50-50449)
onto the base assembly until it sits flush.
Step 4
Remove the logo plate on the stand by
gently using an Exacto knife to release
the plate hook.
Step 5
Position the stand over the base
assembly.
Step 6
Secure the stand to the base assembly
by installing and tightening the M3 set
screw (
MLPN 18-18672) under the logo
plate as shown.
Step 7
Snap the logo plate back into place.
Anchor from
Kit #46-46128
Base Assembly from
Kit #46-46351 or
MS951 Stand Base
Figure 23.
Figure 24.
Figure 25.
Figure 26.
Figure 27.