Metrologic Instruments MS9524 - Manual (Page 8)

4
Figure 1.
Figure 2.
Figure 3.
O PERATIONAL T EST
1. Connect the 10-pin RJ45
male connector into the
jack on the Voyager
PDF .
You will hear a ‘click’ when
the connection is made.
2. Connect the L-shaped plug
of the power supply into
the power jack on the
PowerLink cable.
3. Connect the power supply
into an AC outlet. Make
sure the AC input
requirements of the power
supply match the AC outlet.
4. When the Voyager PDF is
ready to scan, the blue
LED will turn on, the white
LED will flash and the
scanner will beep once.
5. Place a bar code in front of
the scanning window. The
scanner will beep once and
flash the white LED if the
bar code was successfully
decoded and transmitted
(default mode only).
For the MS9544, press the
CodeGate
® button to transmit
the data. (See page 10.)
VoyagerPDF is shipped from the factory programmed with default
settings. Refer to the MetroSelect
® Programming Guide or MetroSet ® 2’s
help files for instructions on how to configure the scanner.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must
meet the requirements for SELV (
Safety Extra Low Voltage) according to EN/IEC 60950.
To maintain compliance with standard CSA-C22.2 No. 60950-00/UL 60950 and EN/IEC
60950, the power source should meet applicable performance requirements for a limited
power source.