Metrologic Instruments MS9524 - Manual (Page 9)

5
I NSTALLING THE S CANNER TO THE H OST S YSTEM
MS9524-00/9/11/14/41 and MS9544-00/9/11/14/41
1. Turn off the host system.
2. Connect the 10-pin RJ45 male
connector into the jack on the
Voyager
PDF . You will hear a
‘click’ when the connection is
made.
3. Connect the L-shaped plug of the
power supply into the power jack
on the PowerLink cable.
4. Make sure the AC input
requirements of the power supply
match the AC outlet. Connect the
power supply into an AC outlet.
The outlet should be near the
equipment and easily accessible.
5. Connect the PowerLink cable to
the proper port on the host
system.
6. Turn on the host system.
Plugging the scanner into a port on the host system does not guarantee
that scanned information will be communicated properly to the host
system. The scanner is shipped from the factory programmed with default
settings. Please refer to the MetroSelect Programming Guide
(
MLPN 00-02544) or MetroSet2’s help files for instructions on changing the
scanner’s configuration. In addition, please check that the scanner and
host system are using the same communication protocol.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must
meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC 60950.
To maintain compliance with standard CSA-C22.2 No. 60950-00/UL 60950 and norm EN/IEC
60950, the power source should meet applicable performance requirements for a limited
power source.
Figure 4.