Miller Electric MC-80M - Manual (Page 14)

OM-1592 Page 8
SECTION 5 – MAINTENANCE & TROUBLESHOOTING
ELECTRIC SHOCK can kill.
•
Do not touch live electrical parts.
•
Turn Off cutter, and disconnect input power before
inspecting, maintaining, or servicing.
HOT PARTS can cause severe burns.
•
Allow cooling period before maintaining or servicing.
Maintenance to be performed only by qualified persons.
WARNING
swarn8.1* 2/93
5-1. Routine Maintenance
Turn Off all power before maintaining.
Each Use
Check Tip
Electrode,
And Cup
Check
Trigger
Disabled
System
Every Week
Check
Gas/Air
Pressure
At Cutter
Tape
Torn
Outer
Covering
– –
Clean
And
Tighten
Torch
Connections 3-1
Torch Body
Gas/Air Hose Torch Cable
– –
Replace
Cracked
Parts
3 Months
Cutter
Manual
See
Section
5-2
Cutter
Manual
Ref. ST-800 895
Figure 5-1. Maintenance Schedule