Miller Electric MC-80M - Manual (Page 9)

OM-1592 Page 3
SECTION 3 – INSTALLATION
3-1. Installing Hand-Held Torch
ELECTRIC SHOCK can kill.
•
Do not touch live electrical parts.
•
Turn Off cutter, and disconnect input power before
installing torch.
MOVING PARTS can cause injury.
•
Keep away from moving parts.
HOT PARTS can cause severe burns.
•
Allow cooling period before maintaining or servicing.
WARNING
swarn8.1* 10/91
Turn Off cutter and remove input
power. Remove top of cutter case.
1 Trigger Switch Connector
2 Gas Hose Connector
3 Pilot Lead Terminal
4 Boot
Insert hose and leads through boot.
5 Gas Hose
6 Pilot Terminal
Connect hose and leads as shown.
Reinstall top of case.
Ref. ST-800 895 / ST-800 896
3/8, 5/8 in
Tools Needed:
4
5 1 2
6
4
3 2
1
Rear Panel
Significant DC voltage can remain on capacitors in cutter
after unit is Off. Always discharge capacitors according to
cutter’s Owner’s Manual before installing torch.
Figure 3-1. Installing Hand-Held Torch Into Cutter