Marantz PD4293D - Manual (Page 39)

32
The 2nd line of the “WORKING TIME”:
→
0M ↔ 3M ↔ 6M ↔ 9M ↔ ... ↔ 57M ←
The 1st line of the “WAITING TIME”:
→
0H ↔1H ↔ 2H ↔ 3H ↔ ... ↔ 12H ←
The 2nd line of the “WAITING TIME”:
→
0M ↔ 3M ↔ 6M ↔ 9M ↔ ... ↔ 57M ←
6. Once the setting is completed...
Press the EXIT button several times to return to the
main menu.
To delete the main menu, press the EXIT button once
more.
Information
Ⅵ Setting the time
WORKING TIME
Set the length of time the “INVERSE/WT” mode lasts.
When the WORKING TIME is set to “ON”, the
“INVERSE/WT” mode stays in the on state.
WAITING TIME
Set the length of time until the “INVERSE/WT” mode
starts.
* The “WORKING TIME” and “WAITING TIME” can
be set for up to 12 hours and 45 minutes in units of 3
minutes.
Ⅵ To select “ON” for the “WORKING TIME”...
Set the hours of the WORKING TIME to 0H and the
minutes to 0M. “ON” will be displayed.
Setting the time for “SCREEN WIPER”
Set the “SCREEN WIPER” operation time, “WAITING
TIME”, and “SPEED”.
Example: Setting so that the SCREEN WIPER mode
starts in 30 minutes and proceeds for one and a half
hours.
Perform Steps 1-2 on Page 30, then:
3. Use the
▲ and ▼ buttons to select “SCREEN WIPER”,
then use the ᮤ and ᮣ buttons to select “ON”.
L O N G L I F E
: AUTO
: OFF
: OFF
: ON
RETURN EXIT
PLE
ORBITER
INVERSE
SCREEN WIPER
SEL. OK PROCEED
4. Press the PROCEED button.
The “SCREEN WIPER” screen appears.
S C R E E N W I P E R
: ON
: 1
SEL. ADJ. RETURN EXIT
WORKING TIME
SPEED
5. Adjust the time and speed using the ᮤ and ᮣ buttons
and the
▲ and ▼ buttons.
The mode switches as follows each time the ᮤ and ᮣ
button is pressed.
S C R E E N W I P E R
: 1H
: 30M
: 0H
: 30M
: 1
SEL. ADJ. RETURN EXIT
WORKING TIME
WAITING TIME
SPEED
The 1st line of the “WORKING TIME”:
→
ON or 0H ↔ 1H ↔ 2H ↔ 3H ↔ ... ↔ 12H ←
* The “WORKING TIME” (minutes) and “WAITING
TIME” cannot be set when the “WORKING TIME”
is “ON”.