Minicom Advanced Systems Smart IP Extender - Manual (Page 51)

USER GUIDE
50
Figure 32 SNMP settings
You can change the following parameters:
Enable SNMP Agent - When checked, IP Extender will answer to SNMP requests.
If a community is blank, you cannot perform the request. E.g. if you want to disable
the possibility to reset IP Extender via SNMP, don't set a write community.
Read Community - This is the SNMP community, which allows you to retrieve
information via SNMP.
Write Community - This community allows you to set options and reset IP
Extender or the host via SNMP.
System Location - Type a description of the physical location of the host. This will
be used in reply to the SNMP request "sysLocation.0".
System Contact - Type a contact person for the host. This will be used in reply to
the SNMP request "sysContact.0".
Enable SNMP Authentication Traps -When checked, an SNMP trap will be sent
in case somebody has tried to access IP Extender via SNMP using a wrong SNMP
community.
Enable IP Extender Authentication Traps - When checked, an SNMP trap will be
sent if somebody tries to login via the Web front-end. Both successful and failed
logins trials will be indicated. Furthermore, there will be notification about other
security violations like trying to perform an action via Web front-end for which a
user has no permission.
Enable Host Traps -When checked, IP Extender will send SNMP traps whenever
the host is reset, powered down or powered up.