MediSense PCx - Manual (Page 75)

Questions? Refer to Page 10-13 For Customer Care Information.
8-15
What You See
on the Display
What You Do Comments
5. The administrator will
enter minimum and
maximum numbers
between 1-15.
Key in the minimum
number of digits for a
Patient ID number then
press Enter.
Key in the maximum
number of digits for a
Patient ID number then
press Enter.
The display returns to the
Patient Test, Patient ID
Barcode Menu.
6. The administrator may
customize I2 of 5 by
pressing 1 if I2 of 5 is
bolded (enabled). Press
1 again to access the
Patient ID Barcode
screen.
Activated barcodes appear
in bold type. More than
one Barcode format can be
active at one time. Any
Barcode can be
deactivated by selecting
the corresponding number.
Note: Only Barcodes
1 and 2 can be customized.
7. The administrator will
select one of the
following:
1. No Check Digit
2. USS Check Digit
3. OPCC Check Digit
The display returns to the
Patient ID Barcode
screen.
USS or OPCC will
appear after the format,
if selected.
8. The administrator may
customize Code 39 by
pressing 2 if Code 39 is
bolded (enabled). Press
2 again to access the
Patient ID Barcode
screen.
9. The administrator will
select one of the
following:
1. No Check Digit
2. Use Check Digit
The display shows the
Alphanumeric, Full ASCII
screen.