Metrologic Instruments MS7120 - Manual (Page 26)

22
T ROUBLESHOOTING G UIDE
The following guide is for reference purposes only. Contact a Metrologic
representative at 1-800-ID-METRO or 1-800-436-3876 to preserve the
limited warranty terms on page 39.
All Interfaces
MS7120 Series Troubleshooting Guide
SYMPTOMS POSSIBLE CAUSE(S) SOLUTION
No LEDs, beep
or motor spin No power is being
supplied to the
scanner Check transformer, outlet and
power strip. Make sure the
cable is plugged into the
scanner
No LEDs, beep No power is being
supplied to the
scanner from host Some host systems cannot
supply enough current to power
Orbit. Use the power supply
included with the scanner.
3 beeps on
power up Non-volatile RAM
failure Contact a Metrologic
Representative, if the unit will
not hold the programmed
configuration
Continuous
razz tone on
power up RAM or ROM failure Contact a Metrologic
Representative, if the unit will
not function
Razz tone and
green LED
flash at power
up VLD failure Contact a Metrologic
Representative
Razz tone and
both LEDs flash
at power up Scanner motor failure Contact a Metrologic
Representative
Unit scans,
Communicates
and beeps
twice Same symbol timeout
set too short Adjust same symbol timeout for
a longer time