Mark Levinson 532 - Manual (Page 18)

14
Mark Levinson
Note If you are putting more than one Nº532 power amplifier into the
network, we recommend connecting and configuring the amplifiers
one at a time to avoid identity and control issues between them.
The Web page also has a Restore Defaults button, which resets the
parameters to their factory default values. Clicking the Restore
Defaults button displays a pop-up asking for confirmation; click yes
to restore the factory default values.
Network Setup
Parameters
Accessible only through the Nº532 internal Web page, the network
setup parameters include:
• Static IP Address – provides a fixed IP address. This IP
address is NOT automatically selected; it must be entered. If
DHCP is on, then an IP address doesn’t need to be entered.
IP address 192.168.50.3 is the factory default value.
• Subnet Mask – identifies the subnet mask for the Nº532.
This IP address is automatically assigned by DHCP. If DHCP
is off, then the address must be entered manually and it
must agree with the subnet mask address of the router. IP
address 255.255.255.0 is the factory default value.
• Host Name – indicates the network name given to the
Nº532 amplifier. The factory default name is NO532.
• DHCP – turns the DHCP capability on or off. When
activated, DHCP assigns a unique IP address to the Nº532.
The factory default value is On. We recommend leaving DHCP
set to On.
Note If the system contains more than one Nº532 dual monaural power
amplifier, the Host Name and IP address of each Nº532 must be
changed to unique values.
Connecting With
DHCP
(Recommended)
If you are using a router with DHCP active to connect to the Nº532,
use this procedure. Otherwise, skip to the next procedure.
Connect one Nº532 power amplifier to the router, as described in
the earlier “Connecting the Cables” section. Make sure that
everything is powered off before making cable connections.
1. Turn on the PC and the router. Verify that the router has DHCP
active.
2. Press the Power button on the Nº532.
3. On the computer, open the Internet Explorer Web browser.