Mark Levinson 532 - Manual (Page 23)

19
Nº532 Power Amplifier
Direct Connection If you are not using a router, use this procedure to connect directly
to a computer. For the computer to find the Nº532, the TCPIP and
LAN settings of the computer must be set up. Refer to the previous
procedure, “Setting up the Computer” for instructions.
Connect one Nº532 power amplifier to the computer, as described
in the earlier “Connecting the Cables” section. Make sure that both
the amplifier and the computer are powered off before connecting.
1. Press the Power button on the Nº532.
2. On the computer, open the Internet Explorer Web browser.
3. On the address line (URL), type the static IP address of the
Nº532 (“192.168.50.3” is the default) and press Enter. There
may be a short delay before the Nº532 Web page loads.
4. The Home tab of the Nº532 internal Web page is now displayed.
The tab is in red text to indicate that it is the current page. The
top of the page provides the general status of the Nº532. The
bottom of the page contains the network parameters setup.
5. Update the Host Name of the amplifier. Each Nº532 in the
network MUST have a unique name.
To change the Host Name of the Nº532:
A. Type the new name into the white box to the right of the
parameter. The new name must be made from the capital
letters, A to Z, and the numbers, 0 to 9. Underscores may also
be used.
B. Click the Submit button to save the new value.
6. Update the Static IP address of the amplifier. Each Nº532 in
the network MUST have a unique Static IP address. Be
sure to make note of the new Host Name and IP address.
7. Enter the new host name or IP address into the browser. The
Nº532 Web page loads, reflecting the new information.
8. Power down the Nº532.
The network connection is now complete. Repeat this procedure
with any additional Nº532 power amplifiers.