Network management cards, User manual – MGE UPS Systems 66074 User Manual

Page 32

Advertising
background image

www.mgeups.com

Network
Management Cards

User Manual

T H E U N I N T E R R U P T I B L E P O W E R P R O V I D E R

Network Management Card

– User Manual

34003676EN/GA

Page

32/69

Mode of card operation with server: after any reboot, if this option is enabled, the card tries to recover the

network parameters from the server for 10 sec. If no response is received from the server, the card boots

with the last saved parameters from the previous start. These parameters are those shown on the page

The default value for this parameter is “Enable”

. Note:

The IP address supplied by the DHCP server must be fixed to maintain connection with the clients installed

on the stations to be protected.

Z

Network Upgrade: Authorises (choose enable) remote upgrading of the embedded system on the card
using the Mupgrade tool. Read the “

Maintenance

” section for more details.

Z

Primary DNS server: contains the IP address of the main DNS server ensuring conversion of the domain

name to IP address.

Z

Secondary DNS server: contains the IP address of the secondary DNS server ensuring conversion of the

domain name to IP address if the primary DNS server is not available.

Z

SMTP server: contains the name or IP address of the local server with which the card connects to send e-

mails.

It may be filled in either as host + domain name (DNS resolution), or directly with the IP address

The default value is stmpserver.domain.com . The card uses port 25 to send e-mails.

Z

The Authentication option must be selected if the SMPT server requires this parameter for query

submission (see the RFC 2554 for SMTP authentication) for commercial reasons, access control, etc.

When authentication is selected, the User and Password parameters must be specified for identification

with the local SMTP server.

Default values are MGEUPS/MGEUPS.

Note: The card must be rebooted after any changes to these parameters. See

“System”

Security: the administrator must click on Save and enter his login/password to save any modifications.

Advertising
This manual is related to the following products: