Multi-Tech Systems MT5600ZDX User Manual
Page 28

28
Model MT5600ZDX
Command: Ln
Monitor Speaker Volume
Values:
n = 0, 1, 2, or 3
Default:
1
Description: L0
Select low volume.
L1
Select low volume.
L2
Select medium volume.
L3
Select high volume.
Command: Mn
Monitor Speaker Mode
Values:
n = 0, 1, 2, or 3
Default:
1
Description: M0
Speaker always off.
M1
Speaker on until carrier signal detected.
M2
Speaker always on when modem is off-hook.
M3
Speaker on until carrier is detected, except while
dialing.
Command: Nn
Modulation Handshake
Values:
n = 0 or 1
Default:
1
Description: N0
Disables auto-mode (automatic modulation negotia-
tion); uses connection speed specified in S37. (Equiv-
alent to +MS <automode> subparameter to 0.)
N1
Enables auto-mode. (Equivalent to +MS <auto-
mode> subparameter to 1.)
Command: On
Return Online to Data Mode
Values:
0 or 1
Default:
None
Description: O0
Enters on-line data mode without a retrain. Handling
is determined by the Call Establishment task. Typical-
ly, if a connection is established, this command
connects the DTE back to the remote modem after an
escape (+++).
O1
Issue a retrain and return to online data mode.