Multi-Tech Systems MVP200 - Manual (Page 10)

MultiVOIP Quick Start Guide
10
3. Connect a network cable to the Ethernet 10BASE-T
connector on the back of the MultiVOIP. Connect the other
end of the cable to your network.
4. If you are connecting a station device such as an analog
telephone, a fax machine, or a Key Telephone System
(KTS) to your MultiVOIP, connect the smaller end of a
special adapter cable (supplied) to the Voice/Fax Channel
1 FXS connector on the back of the MultiVOIP and the
other end to the station device.
If you are connecting a PBX extension to your MultiVOIP,
connect the smaller end of a special adapter cable
(supplied) to the Voice/Fax Channel 1 FXO connector on
the back of the MultiVOIP and the other end to the PBX
extension.
If you are connecting an E&M trunk from a telephone
switch to your MultiVOIP, connect one end of an RJ-45
phone cord to the Voice/Fax Channel 1 E&M connector
on the back of the MultiVOIP and the other end to the
trunk.
If you are connecting to an E&M trunk, you need to ensure
that the E&M trunk jumper is in the correct position for the
E&M type trunk. The default E&M jumper position is E&M
type 2. To change the E&M jumper position, perform the
E&M jumper block positioning procedure, which
immediately follows this procedure.
5. Repeat the above step to connect the remaining telephone
equipment to each Voice/Fax Channel on your MultiVOIP.
6. Turn on power to the MultiVOIP by setting the power
switch on the back panel to the 1 (up, On) position. Wait
for the Boot LED on the MultiVOIP to go off before
proceeding. This may take a couple of minutes.
Proceed to the Software Loading section to load the MultiVOIP
software.