Marantz SR5003 - Manual (Page 64)

61
ENGLISH
BASIC
CONNECTIONS
BASIC OPERA
TION
ADV
ANCED
CONNECTIONS
SETUP
ADV
ANCED
OPERA
TION
TROUBLESHOOTING
OTHERS
NAMES AND
FUNCTION
ADV
ANCED
OPERA
TION
OPERATION OF THE MULTI ZONE OUTPUTS WITH
THE REMOTE CONTROL FROM ZONE A
The following operations can be performed when
using an RC101 remote controller (sold separately).
CHANGE THE ZONE CONTROL COMMANDS (RC101)
FOR ZONE A
ZONE A output can be operated from a room where
the unit is not installed. This requires a separately
sold IR receiver. (For connections, see page 21.)
(When operating the unit by Multi ZONE connected)
• ZONE A: ZONE A Control (Default)
• ZONE B: ZONE B Control
Change the control commands for each ZONE.
2.
1.
1. Press SET button and ZONE button until the
SEND indicator blinks twice.
Then backlight fl ashes.
2. Press A ZONE button.
When the procedure is successful, the SEND
indicator will blink twice.
These buttons change a special code of each
ZONE.
POWER ON/OFF
SOURCE
VOL +/–
MUTE
Notes for the Multi ZONE System
• If the Tuner (FM or AM) is active in the main
ZONE, you can not control any function of the tuner.
In this case, You must listen to the same station as the
main ZONE.
OPERATION OF THE MULTI ZONE OUTPUTS WITH
THE REMOTE CONTROL FROM ZONE B
The following operations can be performed when
using an RC101 remote controller (sold separately).
CHANGE THE ZONE CONTROL COMMANDS (RC101)
FOR ZONE B
ZONE B output can be operated from a room where
the unit is not installed. This requires a separately
sold IR receiver. (For connections, see page 21.)
Change the control commands for each ZONE.
2.
1.
1. Press SET button and ZONE button until the
SEND indicator blinks twice.
Then backlight fl ashes.
2. Press B ZONE button.
When the procedure is successful, the SEND
indicator will blink twice.
These buttons change a special code of each
ZONE.
POWER ON/OFF
SOURCE
OPERATION OF THE ZONE SPEAKER OUTPUTS
WITH THE REMOTE CONTROL
To switch to ZONE SPEAKER SYSTEM A control,
perform the following operations with the RC101 set
to ZONE A.
1.
2. 1.
3.
1. Press SET button and POWER ON button until
the SEND indicator blinks twice.
Then backlight fl ashes.
2. Press the DVD button.
Note
Press the TV button at this time to return to the ZONE
settings.
3. Press ENTER button once to lock in the code.
When the procedure is successful, the SEND
indicator will blink twice.