MITSUBISHI ELECTRIC DX-TL4516U - Manual (Page 71)

68
Recorder Title
This item is used to set the recorder title.
The recorder title is displayed on the upper part of the op-
erational mode display.
The recorder title can be input via a personal computer by
using the Web function. ( page 101)
4
6
System 4
Setup Menu
Recorder Title
On Screen Display Setting
step 1. Set the display mode of the recorder title.
On: Displays recorder title.
Off: Does not display the recorder title.
step 2. Input the recorder title by using the characters
shown on the bottom of the screen.
• When “ALERT” appears on the screen, press
HELP button to display the detailed information.
See page 108 for countermeasures.
Monitor Output Adjust
This item is used to adjust the monitor output.
5
6
System 4
Setup Menu
Monitor Output Adjust
On Screen Display Setting
step 1. Adjust the monitor scan mode.
• Adjust the display range of the monitor. Set it
depending on the displaying area of the monitor.
O v e r s c a n : D i s p l a y s o v e r s c a n e d p i c t u r e .
Generally, this setting is suitable for the monitor of
which display range is narrow such as a television
for domestic use.
Underscan: Displays underscaned picture.
Generally, this setting is suitable for the monitor of
which display range is wide such as a liquid crystal
television. The black line may appear on the right
or left side of the picture for each camera.
step 2. Adjust the alpha blend level.
• The picture supplied from the camera can
be viewed through the menu screen being
displayed.
2-1 Menu
• Adjust the see-through level of the menu display.
The degree of transparency becomes lower as
the higher numbered level is set.
2-2 On Screen Information
• Adjust the see-through level of the information
such as the clock or title. The degree of
transparency becomes lower as the higher
numbered level is set.
System (continued) Setup Menu
Reset to Factory Setting
This item is used to reset the menu settings.
7
System 4
Setup Menu
Reset to Factory Setting
step 1. Select “Execute” to initialize menu settings.
The setting of present time, password, user ID and pass-
word of communication, and HDD settings (partition set-
ting) are not reset.
When you execute <Reset to Factory Setting> with the
setting of “IP Address,” “Sub Net Mask,” “Gateway,”
“Service Port Setting” of LAN or menu language selection
changed, the power turns off and the unit restarts.