Building in the appliance, Preparing the appliance – Miele K 9557 iD User Manual
Page 42
Preparing the appliance
^ Slide cover strip a into the holder in
the middle of the appliance as
illustrated with the bumps facing
downwards. The bumps will fit into
the keyhole slots.
^ Position the mains electricity cable so
that the appliance can be connected
easily once installed.
^ Push the appliance three-quarters of
the way into its niche.
When doing this, make sure that the
mains cable does not get trapped.
^ With 16 mm thick furniture walls
Clip spacers
b over the hinges.
^ Open the appliance door.
^ Secure plastic bracket c to the side
opposite the hinges using screws
d
(M5 x 22).
^ Attach fixing bracket e loosely to the
appliance using screws
f.
^ If necessary shorten sealing strip g
to the height of the niche and then
remove the protective foil.
^ Apply sealing strip g to the side of
the appliance on which the door is
opened so that it is flush with the
front edge of the appliance.
Sealing strip
g should meet up with
the lower edge of fixing bracket
e.
Building in the appliance
42