Ppp > ppp configuration – Multi-Tech Systems MultiModem User Manual
Page 21
Chapter 3 – Using the Web Management Software
Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375A)
21
PPP
PPP > PPP Configuration
PPP General
PPP
Enable/disable PPP. Default is Enable.
Dial-on-Demand:
Enable/disable Dial-on-Demand. Default is Enable. If you disable it, the modem will
always stay connected.
Idle Time Out:
Set the amount of idle time that will pass before the modem will timeout. Default is
180 seconds.
Connect Time Out:
Set the amount of seconds to wait for a connection while in receive mode before
timing out.
Dialing Max Retries:
Enter the number of dialing retries allowed. Default is zero, which means an infinite
number is allowed. Range 0 to 100.
Authentication
Authentication Type:
Set the authentication protocol type that will negotiate with the remote peer:
pap/chap/pap-chap. Default is pap-chap.
User Name:
Enter the User Name with which the remote peer will authenticate. Default is
ipmodule.
Password:
Enter the Password with which the remote peer will authenticate. Default is ipmodule.