Ppp > wakeup on call – Multi-Tech Systems MultiModem User Manual
Page 22
Chapter 3 – Using the Web Management Software
Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375A)
22
ICMP Keep Alive Check
Keep Alive Check:
Enable/disable the Keep Alive Check. Default is disable.
Host Name:
Enter the Host Name.
Interval:
Default is 30 seconds.
Count:
Default is 10.
Modem Configuration
(Refer to the Customer Activation Notices included with the product for proper
information to enter).
Baud Rate:
Set the serial baud rate. Default is 115200.
Dial Number:
Set the dial number to be dialed. Default is NULL.
For EDGE or GPRS the number is *99***1#.
For CDMA the number is #777.
Dial Prefix:
Set the modem dial prefix. Default is ATDT.
Connect String:
Set the modem connect string. Default is CONNECT.
Init String:
Configure the modem init strings. Init-num can range from 1-5.
Submit Button
Click the Submit button to save these settings. You must click Save and Restart once you have
completed and submitted all the screens on which you have made changes.
PPP > Wakeup on Call
The Wakeup on Call feature allows the modem to wake up and initiate a connection when there is an incoming call. If
you desired some security with this feature, you can setup the modem to wake up based on Caller ID instead of
allowing all incoming to wakeup the modem. This will reduce the cost for a modem to be online and available 24/7.
“Wakeup on Call” Configuration
Wakeup on Call:
Enable/disable Wakeup on Call.
Default is disable.
Time Delay:
Enter the amount of time that will pass between the ring of an incoming call and the
initiated connection.
Init Strings:
Configure the modem initialization strings. Init-num can range from 1-5.
Caller ID Configuration
Add “Wakeup on Call” Caller ID:
To add Caller ID to the Wakeup-on-Call function, enter the Caller ID to
be allowed to wakeup the modem.
After entering the Caller ID, click the Add button.
The Caller ID displays at the bottom of screen. You can enter any number of IDs you
desire. A Caller ID can be edited or deleted using Options, which will be available
once a Caller ID is displayed.
Submit Button
Click the Submit button to save these settings. You must click Save and Restart once you have completed
and submitted all the screens on which you have made changes.