Miele G 7883 - Manual (Page 46)

With the aid of the following guide, minor problems can be fixed without a service
call.
The Miele control unit includes a wide range of fault codes to indicate specific
errors. These fault codes are indicated on the display by a flashing F. . . (Ranging
from F1 up to F30.) If one of these codes appears, please contact the Miele
Technical Service Department at 1-800-991-9380 for assistance.
What if … Possible fault Fix
the machine does not
start? The door is not
properly closed. Close the door firmly.
The fuse is defective
or the breaker has
tripped. Make sure the circuit breaker
has not tripped.
"Fdo" appears in the
display. Follow the instructions to prime
the dispensing system
(see "Programming special
functions DOS 1 - 1.1.2
Priming the detergent system"
and "DOS 3 - 1.2.2 Priming the
neutralizer system")
a few minutes after
starting a program, the
"Fill/Drain" indicator
flashes and the fault
code "F..E" appears in
the display? – The water valves
are closed.
– The filters in the
water inlet hose
are dirty.
– Turn the program selector to
"Stop"
f (the fault code
goes out).
– Press the "On/Off" button to
turn the machine off.
– Open the water valve or
clean the filters (see "Lab
washer care").
– Turn the machine on again
and reselect the program.
Trouble shooting
46