Matsui America DVDR100 - Manual (Page 57)

52
DV
D+R/R
W
Re
cor de
r
For
Your Reference
53
DV
D+R/R
W
Rec
ord
er
RW D D
/ /
d d
e e
For
Your Reference
Handling Precautions
•
Hold the disc by the edges so the surface will not be soiled with
fi ngerprints. (A)
Fingerprints, dirt and scratches can cause skipping and distortion.
•
Do not write on the label side with a ball-point pen or other writing
utensils.
•
Do not use record cleaning sprays, benzine, thinner, static
electricity prevention liquids or any other solvent.
•
Be careful not to drop or bend the disc.
•
Do not install more than 1 disc on the disc tray.
•
Do not try to close the disc tray when the disc is not installed
properly. (B)
•
Be sure to store the disc in its exclusive case when not in use.
If the surface is soiled (C)
Wipe gently with a soft, damp (water only) cloth.
When wiping discs, always move the cloth from the center hole
toward the outer edge.
(If you wipe the discs using a circular motion, circular scratches are
likely to occur, which will cause noise.)
If the disc is brought from a cold to a warm environment, moisture
may form on the disc
Wipe the moisture off with a soft, dry, lint-free cloth before using
the disc.
Improper disc storage
You can damage discs if you store them in the following places:
•
Areas exposed to direct sunlight
•
Humid or dusty areas
•
Areas directly exposed to a heat outlet or heating appliance
Playable disc format
•
DVD, DVD+RW, DVD+R, DVD-RW, DVD-R, CD-DA, Mixed
CD-DA, JPEG fi le disc and Kodak Picture Disc.
Recordable disc format
•
DVD+RW (Application Program)
•
DVD+R
Maintenance
•
Be sure to turn the unit off and disconnect the AC power cord
before maintaining the unit.
•
Wipe this unit with a dry soft cloth.
If the surfaces are extremely dirty, wipe clean with a cloth which
has been dipped in a weak soap-and-water solution and wrung
out thoroughly, and then wipe again with a dry cloth.
•
Never use alcohol, benzine, thinner, cleaning fl uid or other
chemicals. And do not use compressed air to remove dust.
(A)
(B)
(C)
5-2
Disc Handling and Maintenance