Manitowoc Ice S - Manual (Page 49)

Section 4 Maintenance
Part Number 000000966 4-7
Water Dump Valve
The water dump valve normally does not require
removal for cleaning. To determine if removal is
necessary:
1. Set the toggle switch to ICE.
2. Verify the water trough fills with water at the
beginning of the freeze cycle.
3. While the ice machine is in the freeze mode, check
the water trough to determine if the dump valve is
leaking. If there is no or little water in the water
trough (during the freeze cycle) the dump valve is
leaking.
A. If the dump valve is leaking, remove,
disassemble and clean it.
B. If the dump valve is not leaking, do not remove
it. Instead, follow the “Ice Machine Cleaning
Procedure”.
Follow the procedure below to remove the dump valve.
1. Leaving the wires attached, twist coil and rotate it
counter-clockwise1/4 turn.
2. Lift the coil assembly off the valve body.
3. Remove the spring, plunger, and nylon gasket from
the valve body.
NOTE: At this point, the water dump valve can easily be
cleaned. If complete removal is desired, continue with
step 4.
NOTE: During cleaning, do not stretch or damage the
spring.
4. Remove the tubing from the dump valve by twisting
the clamps off.
5. Twist the valve body to remove from mounting
bracket.
Dump Valve Disassembly
! Warning
Disconnect the electric power to the ice machine at
the electric service switch box and turn off the water
supply before proceeding.
SPRING
PLUNGER
DIAPHRAM
VALVE BODY
COIL
MOUNTING BRACKET
NYLON GASKET