Multi-Tech Systems Multimodem RJ-9 - Manual (Page 31)

Chapter 3 – Using the Web Management Software
Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375B) 31
PPP General
PPP Enable/disable PPP. The default is Enable.
Dial-on-Demand: Enable/disable Dial-on-Demand. The default is Enable. If you disable it, the modem
will always stay connected.
Idle Time Out: Set the amount of idle time that will pass before the modem will timeout. The
default is 180 seconds.
Connect Time Out: Set the number of seconds to wait for a connection while in receive mode before
timing out.
Dialing Max Retries: Enter the number of dialing retries allowed. The default is zero, which means an
infinite number is allowed. Range 0 to 100.
Authentication
Authentication Type: Set the authentication protocol type that will negotiate with the remote peer:
pap/chap/pap-chap. Default is pap-chap.
User Name: Enter the User Name with which the remote peer will authenticate. Default is
ipmodule.
Password: Enter the Password with which the remote peer will authenticate. Default is
ipmodule.
ICMP Keep Alive Check
Keep Alive Check: Enable/disable the Keep Alive Check. The default is Disable.
Host Name: Enter the Host Name.
Interval: Default is 30 seconds.
Count: Default is 10.
Modem Configuration (Refer to the Customer Activation Notices included with the product for proper
information to enter).
Baud Rate: Set the serial baud rate. Default is 115200.
Dial Number: Set the dial number to be dialed. Default is NULL.
For EDGE or GPRS the number is *99***1#.
For CDMA the number is #777.
Dial Prefix: Set the modem dial prefix. The default is ATDT.
Connect String: Set the modem Connect String. The default is CONNECT.
Init String: Configure the modem init strings. Init-num can range from 1-5.
Submit Button
Click the Submit button to save these settings. Note: You must click Save and Restart once you have
completed and submitted all the screens on which you have made changes.