Multi-Tech Systems Multimodem RJ-9 - Manual (Page 57)

Appendix C – Firmware Upgrade Using External TFTP Client
Multi-Tech Systems, Inc. MultiModem Wireless Modem with Ethernet Interface (S000375B) 57
Appendix C – Firmware Upgrade
Using External TFTP Client
Follow the steps below to install new firmware from the Multi-Tech Systems, Inc. Web site:
Obtaining the Latest Firmware Version
To obtain the latest version of the firmware, contact you Multi-Tech Sales Representative or contact Multi-Tech
directly by phone or email:
Phone: 763-785-3500 or 800-328-9717
See the Multi-Tech Web site:
www.multitech.com
1. Open the modem/router’s Web Management software using a Web Browser. Enter the Gateway Address
http://192.168.2.1 (default) and complete the login.
2. Go to the IP Setup > General Configuration screen and check the Enable button for Firmware Upgrade
under the TFTP Configuration at the button of the screen.
3. Click Save & Restart located on the Menu bar.
4. Then open the DOS screen by clicking the PC’s Start button and selecting Programs > Accessories >
Command Prompt.
5. At the C: prompt, enter the upload request by typing the following:
tftp -i <ip-address> put <firmware-filename>-tftp.bin AMD-tftp.bin
Then press Enter.
Example: tftp -i 192.168.2.1 put c:\example.bin AMD-tftp.bin (Press Enter)
Definitions of the Upload Request Parameters:
• <ip-address>
Address of the Serial-to-Ethernet Adapter to which you are uploading the firmware image.
• <firmware filename>
Filename under which the firmware file was saved on your PC or local network.
• AMD-tftp.bin <destination filename>
Filename must be AMD-tftp.bin. This is a case-sensitive file name; type it as shown here.
6. After the upgrade is completed, open the Web Management software to see if the new version shows.