Inactive port reasons and actions -23, Step 13, Go to – McDATA 4300 User Manual

Page 87: Step 12

Advertising
background image

Maintenance Analysis Procedures

3-23

Maintenence Analysis Procedures

12

A connection is not allowed because of a SANtegrity authentication
failure. At the EFCM Basic Edition interface, modify the IP address
access control list, product-level authentication settings, port-level
authentication settings, and challenge handshake authentication
protocol (CHAP) sequence to ensure device access to the product.
Refer to the McDATA EFCM Basic Edition User Manual (620-000240)
for instructions.

Was the maintenance action successful?

NO

YES

↓

The product port is operational. Exit MAP.

Contact the next level of support. Exit MAP.

13

As indicated by event code 083, a port is set to an inactive state.

a. At the Event Log, examine the first two bytes of event data.

b. Byte 0 specifies the port reporting the problem. Byte 1 specifies

the inactive reason as listed in

Table 3-10

.

14

A port is inactive because Flexport Technology is disabled. Install the
Flexport Technology PFE key to enable N_Port capability. Refer to

Install PFE Keys (Optional)

.

Exit MAP.

15

A port is inactive because the:

•

Port cannot operate at the product (backplane) speed.

•

Optical transceiver does not support the configured port speed.

Table 3-10

Inactive Port Reasons and Actions

Byte 1

Inactive Port Reason

Action

02

Feature key not enabled.

Go to

step 14

.

03

Switch speed conflict.

Go to

step 15

.

04

Optics speed conflict.

Go to

step 15

.

Advertising