Firmware update, Operating a/v components with the extender, Resetting the extender – Marantz RX9001 User Manual
Page 16
13
RX9001 User Guide
Configuration switch: 2
Operating A/V components with the Extender
The A/V components do not respond to commands from the Extender
• Check if the Busy LED blinks green when you send a command with the Control Panel. If the Busy
LED does not blink, the Extender is not receiving commands from a Control Panel.
• Make sure that the Control Panel is configured correctly in Wizz.it Ex;
• Make sure that the Extender is configured correctly in the Configuration Tool and connected
properly to the A/V components;
• Make sure that the switches on the Extender are set correctly.
There are duplicate Extender IDs
Using the Extender ID switch, assign a unique ID to each Extender in the same Wireless
Network. Make sure the Control Panel is configured accordingly in Wizz.it Ex.
You can use up to 16 different Extenders in the same Wireless
Network.
Resetting the Extender
This is only necessary when the Extender shows unusual behavior.
To perform a reset, unplug the power adapter from the Extender. Wait a few seconds, and plug it in
again.
Firmware Update
When an update of the Extender firmware is available, this will be announced on the Marantz
website: http://www.marantz.com (in the Home Entertainment section of your region).
Note
You can always see the current version of the firmware in the Configuration Tool.
1
Download the new version of the firmware on the PC and save it in the desired
location.
2
Unplug the Extender. You can now update it in one of the ways described below.
Updating the Extender with the Configuration Cable
1
Connect the Extender to the PC with the configuration cable (this is the crossed
Ethernet cable enclosed).
2
Make sure that the PC is switched to DHCP while the Extender is in configuration
(normally, this should already be the case).
3
Set the Configuration switch to 2 for configuration:
The Extender will restart. After start-up, the Power and Ethernet LEDs are green and the Busy
LED is red/green blinking.
4
Open the browser.
5
Type the IP address of the Extender in the address bar of the browser: 192.168.8.80.
(This is also printed on the back of the Extender.)
You may have to refresh the browser before the Configuration Tool appears.
RX9001_SG_EFS.qxd 29-03-2007 16:29 Pagina 16