Insignia INSIGNA NS-C5112 - Manual (Page 6)

4
Insignia NS-C5112 CD Car Deck with HD Radio Receiver
www.insignia-products.com
Parts
Make sure that you have the following parts:
Installing the front panel
To install the front panel:
1 Align the notch on the front panel with the
post on the right side of your car deck, then
push the panel in slightly.
2 Slide the panel slightly to the right.
3 Swing the panel up until it snaps into place.
Removing the front panel
To remove the front panel:
1 Push the REL button to release the front
panel.
2 Pull the front panel toward you until it is at a
45 ° angle, then slide it to the left to remove it.
Installing your car deck
There are two methods for installing your car
deck into the vehicle’s dash.
DIN front-mount
To install using the DIN front-mount method:
1 Slide the mounting sleeve into the opening in
the vehicle’s dash.
Part Description
Mounting sleeve (1)
Rear mounting bolt (1)
Harness rubber (1)
Screws (M5 × 5)
Outer trim (1)
Keys (2)
Connecting wire (1)
Steel bar (1)
Post
Notch
REL button