Ikelite ALL - Manual (Page 5)

5
Closing the Housing
Rotate the hinged back onto the housing front. Close the latch and make
sure it locks. Latch will “click” into it’s locked position. Latch buttons will
NOT be depressed when latch is properly locked, see diagram A, page
4. Return housing controls to their operating position. Make sure the
housing controls line up with the camera controls.
Installing the Camera
Remove any lanyard
attached to your
camera. Pull out on
housing controls
until they stop.
Place the camera
face down into the
front housing ribs as
shown, diagram D.
Safety Check
Inspect the o-ring seal through each side of the housing. A good
seal should appear as a solid black line. Make sure that no stray hairs,
lanyards, or other objects cross the o-ring seal.
Main Housing O-ring
Check to see that there is an o-ring
on the housing back and that it is
clean, lightly lubricated, and in its
proper location, diagram C. Only
apply enough lubricant to make the o-ring feel slick. Too much
lubricant can attract debris and adversely affect the housing seal.
Too little lubricant can result in difficulty closing the housing.
O-ring
Housing Back - Side View
Diagram C
PUSH
T
O
UNL
OCK
Diagram D