Ikelite ALL - Manual (Page 8)

8
Entering the Water
As soon as you enter the water, take a moment and check the housing
to see that it is properly sealed.
Next, check to see if there are any bubbles on the face of the lens port.
If there are, take your finger and remove them. If there are bubbles on
the lens port they can produce soft focus spots in your photos or video.
Maintenance
Lens Port
Treat the glass in the lens port as a camera lens. After use, rinse and
gently dry the outside lens port to avoid water spotting. To clean, use a
mild soap solution or lens cleaner. Do not rinse the inside port glass. Do
not use alcohol or window cleaner on the Lens Port.
Control Maintenance
Ikelite controls are designed to provide years of reliable service with
minimal maintenance.
Push button controls require no maintenance other than rinsing in fresh
water after saltwater use. If a push button control becomes difficult to
push, or if it sticks when depressed, soak the housing in luke warm fresh
water. After a few minutes operate the push button. If this does not
correct the problem, return the housing to Ikelite for routine
maintenance.
If a housing control shaft becomes “sticky” and hard to operate, return
the housing to Ikelite for routine maintenance.