IBM SG24-4817-00 - Manual (Page 201)

This soft copy for use by IBM employees only.
1.1.2 What to do if operational code FLASH is corrupted.
If code download terminates abnormally then operational code FLASH
may become corrupted. If this happens then bridge can not forward frames,
or respond to most configurator commands. However, bridge can still
communicate with configurator to load operational code via the serial
port.
1 - Select
″
Load new code image via serial port
″
from
″
Utilities
″
menu.
2 - Choose the image to load.
3 - Select OK.
The configurator will automatically determine that the FLASH is corrupted
and print a message stating that fact.
1.2 Configuration Utility Installation
Before you can use the ATM LAN Bridge Module Configuration Utility
program you have to run the ATM LAN Bridge Module Configuration
install setup program so it will work properly on your computer.
You cannot just copy the files from the Installation disk to your
hard disk. The files on the distribution disk are packed to save space.
The install program unpacks those files and builds them on your working
disk.
1. Make Windows
′ ″
Program Manager
″
the active window.
2. From Windows
′ ″
Program Manager
″,
select
″
File
″,
then
select
″
Run
″.
This will open the
″
Run
″
dialog box.
Place the ATM LAN Bridge Module Configuration Utility Installation
disk in your floppy drive. Type in the dialog box the
command that will run the install program.
If your floppy disk goes in your Drive
″
A
″,
type:
A:INSTALL
If your floppy disk goes in your Drive
″
B
″,
type:
B:INSTALL
Leave the
″
Run Minimized
″
box un-selected, and click the
″
OK
″
command button (or press
″
Enter
″ ) .
3. After a brief moment you will be prompted by a dialog box
to enter the desired location for the ATM LAN Bridge Module
Configuration Utility. This is the location that you want your
Configuration files to be placed.
It will suggest a drive and
directory of
″
C:\IBM8281
″ .
If you want the ATM LAN Bridge Module Configuration program files
installed on a different drive or directory, just click the pointer to
the right of the characters you want to change, backspace over
the ones you want to erase, then type in the new designation.
4. The install program will unpack the necessary files and
place them into your directory.
The status of the operation
will be displayed as the setup program does this work.
Appendix D. Hints and Tips for the ATM 4-Port TR/Ethernet Bridge Module
185