IBM SG24-4817-00 - Manual (Page 242)

This soft copy for use by IBM employees only.
-- Dumps
dumps OBJECT IDENTIFIER ::= { service 2 }
-- dumps.1 intentionnally left unused
trsDump OBJECT-TYPE
SYNTAX INTEGER { ready (1),
start (2)
}
ACCESS read-write
STATUS mandatory
DESCRIPTION
″
When start is selected, a dump of the Topology and Route
Services component is taken.
The dump is stored in the hub in a file that can be
retrieved through TFTP.
″
::= { dumps 2 }
-- Microcode swap
swap OBJECT IDENTIFIER ::= { service 3 }
swapControl OBJECT-TYPE
SYNTAX INTEGER { ready (1),
swap (2)
}
ACCESS read-write
STATUS mandatory
DESCRIPTION
″
When swap is selected, the backup microcode image is
checked and, if valid, activated.
The previously active microcode image becomes
the backup image.
The atm subsystem is reset.
″
::= { swap 1 }
swapResult OBJECT-TYPE
SYNTAX INTEGER { not-initialized (1),
swap-successful (2),
swap-in-progress (3),
checksum-error (4) }
ACCESS read-only
STATUS mandatory
DESCRIPTION
″
The result of the latest microcode swap.
When an operational code image is downloaded or
when the system is reset, swapControl becomes
not-initialized.
″
::= { swap 2 }
swapBackupVersion OBJECT-TYPE
SYNTAX DisplayString
ACCESS read-only
STATUS mandatory
DESCRIPTION
226
ATM Workgroup Solutions: Implementing the 8285 ATM Switch