Intermec PX4I - Manual (Page 101)

$PEFS


19J
9
8 7
10
EasyCoder PX4i User’s Guide (IPL version) 87
Chapter 10 — Maintenance
Connect the two cables to the replace-
ment printhead.
Fit the hooks of the printhead bracket
fi ngers onto the headlift shaft. Make
sure that the cables do not prevent the
bracket fi ngers from being properly
seated on the headlift shaft.
Load a new supply of media and ribbon,
as described earlier in this manual. Close the printhead so the magnet
engages the printhead bracket.
Printhead Replacement, cont.