Intermec PX4I - Manual (Page 70)

56 EasyCoder PX4i User’s Guide (IPL version)
Chapter 6 — Setting Up the Printer
Darkness
Use this parameter to make minor adjustments of the blackness in
the printout, for example to adapt the printer to variations in quality
between different batches of the same media quality. The value can be set
within the range -10% to +10% where -10 is the lightest and 10 is the
darkest. Default value is 0%.
Label Rest Point
Specifi es where labels stop for removal. Use this for peel-off (self-strip)
applications. Allowed range is -30 (furthest back) to 30 (furthest for-
ward). Default is 0. Also available as an IPL command (
<SI>fn
).
Form Adj Dots X
Specifi es where the X-position of the origin should be placed on the
label. Allowed range is -30 (closest to the leading edge) to 30 (furthest
from the leading edge). Default is 0.
Form Adj Dots Y
Specifi es where the Y-position of the origin should be placed on the label.
Allowed range is -30 (closest to the center section) to 30 (furthest from
the center section). Default is 0.
Ribbon Low
Specifi es the value in millimeters of the ribbon supply roll for the ribbon
sensor. When the diameter of remaining ribbon supply roll reaches the
set value, an SNMP trap is sent to the printer’s home page, provided the
printer has an optional EasyLAN connection. Range: 0-80 with preset
values at an interval of 5. A value larger than 80 sets the ribbon sensor to
0. Default value: 0.
The ribbon low sensor can also be set using an IPL command:
<STX><SI>kn<ETX>
Paper Low
Specifi es the diameter in millimeters of the media supply roll for the
paper sensor. When the diameter of remaining media supply reaches the
set value, an SNMP trap is sent to the printer’s home page, provided the
printer has an optional EasyLAN connection. Range: 0-150 with preset
values at an interval of 10. A value larger than 150 sets the paper sensor
to 0. Default value: 0.
The ribbon low sensor can also be set using an IPL command:
<STX><SI>jn<ETX>