Infinite Peripherals SCOM-100 - Manual (Page 10)

SCOM-100, User guide 10
3. Getting started
3.1 Preparing a SIM card
Before installing the SIM card, use your phone to:
1. Clear the PIN code (no PIN needed).
2. Enter your name and phone number in the first place of the phonebook directory of
the SIM card.
Note: You can alternatively power up the unit without a SIM card and set the PIN
number using a terminal program on a PC, or you can set a PIN in later
configuration stages.
3.2 Installing the SIM card
Note: Always remove or install the SIM card, having the unit powered down!
Insert the card faced down into the cardholder.
3.3 First power up & factory settings
Power up the unit and hold the startup button pressed until the ready LED starts
blinking rapidly.
The unit executes the startup procedure setting all parameters to the factory defaults,
reads the SIM card’s phonebook entry, enters the RUN (Control) mode and sends a
HELLO SMS message to the mobile phone number that was found in the SIM
phonebook entry.
LED indication states are:
1. READY LED will switch on indicating the successful reading of the SIM card’s
phonebook entry.
2. STATUS LED will switch on indicating the RUN (Control) mode.
3. NETWORK LED will be blinking to state successful connection to the GSM
provider’s network.