Intermec 6620 - Manual (Page 66)

SECTION 3 6620 Recovery Procedures
3-4 6620 Hand-Held Computer Technical Reference
Using a Parallel CD-ROM Drive
It is possible to use a parallel CD-ROM to restore Recovery
Windows as long as you have real mode (DOS) support driv-
ers as well as 32-bit (Windows) drivers that support long
filenames.
Create a CD-ROM Emergency Recovery Floppy using the
procedure described on page 3-11. Modify the
CDSUPP.BAT and CDCONF.SYS files on the floppy; these
become AUTOEXEC.BAT and CONFIG.SYS respectively
during the recovery process to support your specific CD-
ROM drive. You also must modify CDSUPP.BAT to copy
your own driver files to the hard disk.
Recovering “Main Data” Partition
See the following “Main Data Recovery” section for detailed
instructions on this procedure.
Main Data Recovery
These methods recover the “Main Data” partition:
"
Recovering from Network Drive (if network available)
"
Recovering from parallel CD-ROM
"
Recovering from PC Card (if a slot is available in the
6620 to be recovered)
" NOTE: It is possible to network two different 6620 Computers in docks with a
network hub to allow for rapid reimaging or image-to-image copying.
For more information on “Image-to-Image” copying, see page 3-20.