Intermec 6620 - Manual (Page 67)

SECTION 3 6620 Recovery Procedures
6620 Hand-Held Computer Technical Reference 3-5
Activating the Recovery Windows
Partition
" NOTE: Steps 1–3 are not needed if you are in the middle of a Complete
System Recovery with “Recovery Windows” already activated.
1. Boot the 6620 Computer with the 6620 Emergency Re-
covery Disk. The computer should be docked with the
parallel disk drive connected. Let the “Automation
Utility” start.
2. Press “2” to activate “Recovery Windows.”
3. When prompted, eject the disk to boot to the recovery
partition. The computer boots from the hard drive.
Actual Recovery of the Main Data
Partition
Recovering from Network Drive
" NOTE: Preparing a network share and ensuring the network transports and
drivers are installed properly on the remote system is beyond the
scope of this document.
On the Remote Machine
Insert the 6620 Toolkit CD. Ensure that the CD drive is
shared and note the Share name.
On the 6620 Computer to be Recovered
Ensure that the Ethernet card is enabled in the BIOS Set-
up, advanced options, integrated peripherals.
1. Restart “Recovery Windows” and log in.
2. On newer systems, double-click a “Recover” icon
(shown left) from the Windows desktop. If there is a
prompt mentioning an existing drive, press “Y” for yes,
then press [Enter].
If your system does not have this icon, find the remote
share and mount it as drive Z.