IOGear GCS1784 - Manual (Page 12)

12 13
Hardware Setup
Make sure that power to all the devices you will be installing has been turned off. You must
unplug the power cords of any computers that have the Keyboard Power On function.
Cable Connection
To set up your GCS1782 installation, refer to the installation diagrams on the following pages (the
numbers in the diagrams correspond to the steps, below), and do the following:
1. Connect your USB keyboard and mouse into the USB Console Ports located on the unit’s back
panel.
2. Connect your microphone, speakers, and monitor into the Console ports located on the unit’s rear
panel
Note: The IOGEAR KVM cable set provided 2.1 channel surround sound only. You must use the
included audio cable for 7.1 audio
3. Using the KVM cable set, connect the DVI connector into any available DVI socket in the CPU Port
setion of the switch, then connect the accompanying USB, microphone and speaker connectors
into their corresponding USB, microphone, and speaker sockets.