IBM PS1500 - Manual (Page 100)

○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
5•12 User Guide
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
MODIFYING THE CHORD RECOGNITION
MODES
The three chord recognition modes are accessed
by holding the PIANO STYLE button pressed for
approximately 2 seconds.
1. Press and hold PIANO STYLE.
2
1
PIANO STYLE
1/1 PIANO STYLE:ONE FINGER
OneFinger Fingered1 Fingered2 FreeStyle
F1 F2 F3 F4 F5 F6 F7 F8
1/1 PIANO STYLE:FINGERED 2
OneFinger Fingered1 Fingered2 FreeStyle
ENTER ESCAPE
3
2. Select the required chord recognition mode with
the corresponding Function buttons.
F1/F2 select ONE FINGER;
F2/F3 select FINGERED 1;
F3/F4 select FINGERED 2;
F7/F8 select FREESTYLE.
3. Press ESCAPE to close the PIANO STYLE display.
4. Press STORE PRESET and ENTER to save to the
current Preset.
The chord recognition modes are Preset pa-
rameters, therefore, the Programmable Pre-
sets can be independently programmed to
recall different chord recognition modes.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
ᮣ N.B.: The recognized chord symbols appear on
the main Style display. If an unrecognized chord is
played, the chord symbol for the lowest note
appears followed by a series of asterisks. For
example: “C*****”.
ᮣ N.B.: In order for the chord to be recognized
(and for its symbol to be shown on the display)
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
.EASY PLAY must be on.
HARMONY
TYPE ON OFF
4 STORE
PRESET
ENTER ESCAPE
Modifying the Chord Recognition mode
Preset Store:01GrandP TO:01GrandP
Are you sure? Press [ENT] or [ESC]