IntraServer Technology ITIpci 5100G/GF - Manual (Page 17)

LSI Logic Corporation Page 17 of 56
Figure 4: ITI-5100G adapter faceplate
The faceplate of the ITI-5100G adapter has one 10/100/1000Base-T twisted
pair copper (CAT-5) connector for connecting the adapter to a Gigabit
Ethernet segment. The adapter will also operate in an existing 10/100
Ethernet environment.
ITI-5100G Port LED Activity
LED State Description
Data
Blinking
On
Off Data detected on the port.
Data detected on the port.
No data detected on the port.
1000
On
Off Good link. at 1000Mb/sec
No link; possible bad cable, bad connector, missing or
improperly installed driver software, or configuration
mismatch.
100
On
Off Good link. at 100Mb/sec
No link; possible bad cable, bad connector, missing or
improperly installed driver software, or configuration
mismatch.
10
On
Off Good link. at 10Mb/sec
No link; possible bad cable, bad connector, missing or
improperly installed driver software, or configuration
mismatch.
Table 4: ITI-5100G LED Status Indicators
10/100/1000
BAS
E
-T
DAT
A
1000 100 10