Intel MD566X - Manual (Page 54)

56K V.92 Data, Fax, and Voice Chipset
54 Intel Confidential Programmer’s Guide
&Yn 0
Select Stored Profile on Power-up: This command selects the particular
stored user profile from the NVRAM to be loaded into the active profile upon
modem power-up.
n = 0** Select profile 0
n = 1 Select profile 1
&Zn=x none
Store Telephone Number: This command stores a telephone number up to
30 digits (including dial modifiers) in the NVRAM. To dial the stored tele-
phone number, use the ATDS=n command. Use the
&V command to see the
stored telephone number.
n = 0–3
x = 0–9 A B C D # * T P R W @ , ! ;
%En 1
Auto-Retrain Control: This command controls whether the modem auto-
matically initiates a modem retrain whenever the received data signal quality
falls below a threshold that may affect data reliability. The value for ‘n’ is
stored in the NVRAM.
n = 0 Disabled
n = 1** Enabled
%Gn 1
Rate Renegotiation: This command selects whether the modem automatically ini-
tiates a change to a higher speed or lower speed depending on received signal qual-
ity (that is, rate negotiation). The modem always responds to any rate change initi-
ated by the remote modem.
n = 0 Disabled
n = 1** Enabled
Table 3-4. Data Mode Command Descriptions (Continued)