Integra DSR-4.8 - Manual (Page 29)

29
Initial Setup
This chapter explains the settings you need to make the
very first time the DVD receiver is turned on.
Basically this manual contains procedures using the
remote controller.
The very first time you turn on the DVD receiver, the
“Initial Setup” menu appears onscreen.
Here you need to make a few settings to get the DVD
receiver up and running. You can change these settings
later (see page 57).
Note:
You can cancel the “Initial Setup” by pressing the
[Setup] button and complete the settings later by using
the onscreen setup menus (see page 57).
First Time Setup
Enter
Initial Setup
TV Shape
On-Screen Language
HDMI Output Setting
16:9 Widescreen
4:3 Pan Scan
16:9 Compressed
4:3 Letter box ✔
1 Use the Up and Down [ ]/[ ]
buttons to select “TV Shape”,
and then press [Enter].
Select “4:3 Letter box” or “4:3 Pan
Scan” if you have a 4:3 TV. Select
“16:9 Widescreen” or “16:9 Com-
pressed” if you have a widescreen TV.
See page 59 for more information.
The “HDMI Output Setting” menu
appears next.
2 Use the Up and Down [ ]/[ ]
buttons to select “On” or “Off”
for “HDMI Output Setting”, and
then press [Enter].
Select “On” to use the HDMI output.
The “On-Screen Language” menu
appears next.
3 Use the Up and Down [ ]/[ ]
buttons to select a language, and
then press [Enter].
See page 61 for more information on
the language options.
The “Initial Setup” menu closes and the
setup is complete.
The DVD receiver is now ready to use.
Initial Setup
TV Shape
On-Screen Language
HDMI Output Setting
16:9 Widescreen
4:3 Pan Scan
16:9 Compressed
4:3 Letter box ✔
Initial Setup
TV Shape
On-Screen Language
HDMI Output Setting
Off
On
: 4:3 Letter box
✔
TV Shape
On-Screen Language
HDMI Output Setting
English
Français
Español
Deutsch
Italiano
: 4:3 Letter box
: On
✔