Integra DSR-4.8 - Manual (Page 60)

60
DVD Onscreen Setup Menus—Continued
Progressive Setting
With this setting you can set the component video output
to progressive or interlaced. While the “HDMI Output
Setting” is set to “On”, this setting is fixed at “Progres-
sive” and cannot be changed. See page 30 for more
information.
Interlace:
Component video output is interlaced.
Progressive (default):
Component video output is progressive.
Tip:
When the “HDMI Output Setting” is set to “Off”, you
can also change this setting by using the remote control-
ler’s [Resolution] button (see page 30).
HD Resolution
With this setting you can set the video resolution for the
HDMI OUT. See page 30 for more information.
Auto:
The resolution is automatically set to the native resolu-
tion of the TV connected to the HDMI OUT.
480p (default):
The setting displayed depends on the country in which
you purchased the DVD receiver.
720 x 480p 60 Hz
720p:
1280 x 720p 50/60 Hz
1080i:
1920 x 1080i 50/60 Hz
Tip:
When the “HDMI Output Setting” is set to “On”, you
can also change this setting by using the remote control-
ler’s [Resolution] button (see page 30).
Note:
Initially, the DVD receiver is configured to output both
HDMI and analog video. However, if after changing the
resolution settings there’s no picture, with the analog
video connection or HDMI connection in place, press
the [Resolution] button repeatedly to restore the picture.
HD JPEG Mode
If your TV is connected to the HDMI OUT and the
HDMI resolution is set to 720p or 1080i, this setting
allows you to display your JPEG pictures in high defini-
tion.
On:
JPEG pictures displayed in high definition.
Off (default):
JPEG pictures displayed as normal.
Notes:
• If your TV is connected to a video output other than
the HDMI OUT, or the HDMI output resolution is set
to something other than 720p or 1080i, even if this set-
ting is set to “On”, your JPEG pictures will not be dis-
played in high definition.
• When using HD JPEG, it may take a while to display
each picture. And the Zoom function cannot be used.
Also, onscreen status messages such as “Play” and
“Stop” are not displayed.
Video Black Level
With this setting you can adjust the picture blackness for
the analog video outputs. It does not affect the compo-
nent video output when its set to progressive.
Light:
Blacks are lighter, and the entire picture becomes lighter.
Dark:
Blacks are darker, and the entire picture becomes darker.
Brightness
With this setting you can adjust the picture brightness.
Level 1-7:
“1” is the darkest. “7” is the brightest. The default bright-
ness is “4 (standard)”.
Sharpness
With this setting you can adjust the picture sharpness.
Level 1-7:
“1” is the softest. “7” is the sharpest. The default sharp-
ness is “4 (standard)”.