IBM TIVOLI ADSTAR 5697-VM3 - Manual (Page 21)

VMFINS276 I VMFINS processing started
VMFINS19 9I VMFINS PRODLIST created on your A-disk
VMFINS276 I VMFINS processing completed successfully
Ready;
8
Obtain resource planning information for Tivoli ADSM for VM.
Note: The product will not be loaded by the VMFINS command at this time.
vmfins install ppf 5654A09A {ADSM | ADSMSFS} (plan nomemo
Use ADSM for installing on minidisks or ADSMSFS
for installing in Shared File System directories.
The PLAN option indicates that VMFINS will
perform requisite checking, plan system resources,
and provide an opportunity to override the defaults
in the product parameter file.
You can override any of the following:
the name of the product parameter file
the default install user ID
minidisk/directory definitions
Notes:
a. If you change the PPF name, a default user ID, or other parameters via a
PPF override, you will need to use your changed values instead of those
indicated (when appropriate), throughout the rest of the installation
instructions, as well as the instructions for servicing Tivoli ADSM for VM.
For example, you will need to specify your PPF override file name instead
of 5654A09A for certain VMSES/E commands.
b. If you're not familiar with creating PPF overrides using VMFINS, you
should review the "Using the Make Override Panel" section in Chapter 3
of the VMSES/E Introduction and Reference before you continue.
c. For more information about changing the VMSYS file pool name refer to
Chapter 3 in the VMSES/E Introduction and Reference.
Installation Instructions
17