IBM TIVOLI ADSTAR 5697-VM3 - Manual (Page 53)

2
Create (or modify as required) the Variable Declarations (:DCL.) section for
the ADSMSFS override area so that it resembles the :DCL. section as
shown below.
:OVERLST. ADSMSFS
ᑍ
ᑍ=========================================================ᑍ
:ADSMSFS. ADSM 5654A 9A
ᑍ=========================================================ᑍ
:DCL. UPDATE
&PROD191
DIR MYPOOL:5654A 9A. ᑍ 5654A 9A Userid A-disk
&BASE DIR MYPOOL:5654A 9A.ADSM.OBJECT ᑍ Initial Product code
&APPLY1 DIR MYPOOL:5654A 9A.ADSM.APPLYPROD ᑍ Production APPLY disk
&APPLY2 DIR MYPOOL:5654A 9A.ADSM.APPLYALT ᑍ Alternate APPLY disk
&DELTA1 DIR MYPOOL:5654A 9A.ADSM.DELTA ᑍ Production DELTA disk
&5654A 9A USER 5654A 9A ᑍ ADSM Code Owner Userid
:EDCL.
:END.
ᑍ=========================================================ᑍ
ᑍ
This override will replace the :DCL. section of the adsmsfs override area of the 5654A09A $PPF file.
3
If your $PPF override file was created at file mode A, copy it to file mode
D—the Software Inventory minidisk (MAINT 51D).
file
copyfile overname $PPF fm = = d (olddate
4
Compile your changes to create the usable overname PPF file.
vmfppf overname adsmsfs where overname is the file name of your $PPF
override file.
Now that the overname PPF file has been created, you should specify overname
instead of 5654A09A as the PPF name to be used for any VMSES/E commands
that require a PPF name.
Appendix C. Moving Tivoli ADSM for VM to SFS Directories and Creating PPF Override
49