IBM TIVOLI ADSTAR 5697-VM3 - Manual (Page 32)

Build New Levels
The build task generates the serviced level of an object and places the new object on a test BUILD
disk.
Place the New Service into Production
Once the service is satisfactorily tested it is ready to put into production by copying the new service to
the production disk.
7.2 Servicing Tivoli ADSM for VM
RSU Warning
If applying a Tivoli ADSM for VM RSU go to the instructions in Appendix A, “Applying an RSU Tape
for Tivoli ADSM for VM” on page 36. You will return to a step in this chapter as specified in that
appendix.
7.2.1 Prepare to Receive Service
The ppfname used throughout these servicing instructions is 5654A09A, which assumes you are using the
PPF supplied by IBM for Tivoli ADSM for VM. If you have your own PPF override file for Tivoli ADSM for
VM, you should use your file's ppfname instead of 5654A09A. The ppfname you selected should be used
throughout the rest of this procedure, unless otherwise stated differently.
1
Logon to Tivoli ADSM for VM service user ID 5654A09A
2
If the Software Inventory disk (51D) was accessed R/O (read only) then
establish write access to the Software Inventory disk.
Note: If the MAINT 51D minidisk was accessed R/O, you will need to have
the user that has it accessed R/W link it R/O. You then can issue the
following commands to obtain R/W access to it.
link MAINT 51d 51d mr
access 51d d The 51D minidisk is where the VMSES/E Software
Inventory files and other product dependent files
reside.
3
Have the Tivoli ADSM for VM CORrective service tape mounted and attached
to 5654A09A.
4
Establish the correct minidisk access order.
vmfsetup 5654A09A {ADSM | ADSMSFS}
28
Tivoli ADSM for VM Program Directory