IBM -4900 - Manual (Page 21)

LIST OF SYSTEM DEFAULTS
The default telephone setup is as follows:
Function
Tone/Pulse Mode
Headset
Extension Number
Ringer
Line Connection
Speaker Volume
Handset Volume
Headset Volume
Ringer Volume
Speed Dial
Area Code
Calendar
Caller ID Log
Default
Tone
Disable
I I
On 4 lines
On 4 lines
level
Middle level
Middle level
Middle level
Empty
Empty
Jan 0 I Fr am
Empty
You may clear all programmed data and all the parameters will revert to the above default values. To
do this:
I. Press [STORE].
2. Press
3. Press [MUTE].
4. A short ring will be heard to signal successful programming.
ASSIGNING EXTENSION NUMBERS (I I THROUGH 22)
When you use two or more phones, each phone must be assigned a different extension number. If two
stations are given the same number, you will hear a loud continuous warning alerting you to the system
error.
All phones arrive with the default extension number I I. Valid extension numbers are I I through 22.
To program extension numbers, follow these steps, assigning numbers sequentially to each extension:
I. Press [STORE].
2. Press [I], [O].
3. Enter 2 digits XX where XX is a number from I I to 22.
4. Press [MUTE].
5. A short ring will be heard to signal successful programming.
22
SMARTHOME.COM™ 1-800-SMART-HOME 949-221-9200 http://www.smarthome.com Order #5125C