Intel ATOM US15W - Manual (Page 37)

Reference Board Summary
User’s Manual 37
Document Number: 320264
1. Extract all files (keep them in the same folder) to a single directory of your choice
on the host machine or on a floppy disk (recommended).
2. Connect a NULL modem cable to the serial ports of each platform (host and unit to
be flashed).
3. With the board powered off, move the jumpers listed in Table 14 to the
programming stuffing option.
4. Attach an ATX power supply to the system and power up the board.
5. Boot the host system into a DOS environment using DOS bootable media
6. Install a serial port onto the target board header J9F1.
7. Hook up a null modem cable.
8. From the directory where you extracted the files on the host machine, run the
“kscflash ec_xx.bin /remote” command to program H8 through the serial port.
9. Follow the flash utility instructions.
10. With the board powered off, return the jumpers to their default settings.
Note: Make sure the board is not powered on, and the power supply is disconnected before
moving any of the jumpers.